When using the chainsaw chain
, pay attention to loosening the knob of the pressing device and removing the pressing cover. Install one end of the chainsaw chain on the sprocket, the other end of the saw chain on the guide plate, and the middle guide teeth just snap into the guide groove of the guide plate. Note: The teeth of the chain are facing forward! Attach the guide to the cordless chainsaw. The charging chainsaw has a device to adjust the tension of the chain. When installing the guide plate, the adjustment block must be inserted into the positioning adjustment hole at the end of the guide plate. Place the compression cap on the guide and turn the compression knob clockwise. Turn the chain tension knob to adjust the tension of the chainsaw chain. The adjustment standard is: lift the chain in the middle of the guide plate by hand to expose the middle guide teeth. Tighten the compression knob, and the chain saw guide and chain are installed. Note: The chain will be stretched at the beginning of the use of the new chain. Please check it frequently and adjust it to the appropriate tension, because the loose chain length is easy to derail, which may lead to rapid wear of the chainsaw chain and guide plate. The chain must be stuck on the sprocket, please check again after installation is complete.
The old chain cannot be mixed with some new chainsaw chains, otherwise it will easily cause shock in the transmission and break the chain. The chainsaw chain should be filled with lubricating oil in time during work. Lubricating oil must enter the fitting clearance of the roller and the inner sleeve to improve working conditions and reduce wear. The use of chain drive is a kind of knowledge, we must sum up experience in use, it is the equipment that exerts its special capabilities, saves money for the company, and achieves greater benefits.